HomeAbout UsTerms and Conditions LinksBusiness OpportunitiesContact UsNews
Products
Water purifiers
Air purifiers
Waterless cookware
Juice Extractors
Cutlery
Food storage containers

Things to know
Facts about water
Facts about air
Cookware info & FAQ
Juicing facts
Vacuum packing


Drinking Water System Faucet

This deluxe drinking faucet is designed for use in mounting holes up to 1 1/2" in diameter.

STEP1. Assemble Top Parts

Slip Finished flange up threaded shank, followed by rubber gasket.

STEP 2. Insert Into Sink Mounting Hole

With finished flange and rubber gasket assembled, insert threaded shank of faucet down through mounting hole.

STEP 3. Tighten From Below Deck

From underside of sink, slip unfinished brass flange (same size as top flange, but unfinished) up threaded shank of faucet and tighten in place with mounting nut. (Be sure to give faucet proper alignment on top before final tightening.)

STEP 4. Make Supply Attachment

a) Slip compression nut over end of 1/4" o.d. supply tube, threads facing end. Press ferrule onto end of tube. Insert tube into end of threaded faucet shank and tighten compression nut.
b) NOTE: If supplied with quick-connect faucet connection, thread quick connect faucet connection onto faucet shank. Cut copper or plastic tubing squarely with no burred edges. Insert into faucet connection as far as it will go. If you need to remove tubing, push back on dark gray ring. Use locking clip if required.

STEP 5. Check For Leaks

Turn on supply stop valve feeding faucet. Check for leaks at compression connection. Apply additional tightening, if necessary. Shut off supply stop valve feeding faucet. Loosen screw and remove handle and sleeve. Using wrench,
remove and replace ceramic cartridge.

* COMPLIES WITH NSF 61.9 *

<< Back to Water Purifiers

 

  Copyright © 2005, Water Products 6798179 Canada Ltd.
Service site for BelKraft International